Precautions For Operating The Slitting Machine
Oct 16, 2023
Leave a message
1. During use, you should always pay attention to observe whether the components are operating normally and whether there are any abnormal sounds. If there is any abnormal sound, stop the machine in time to find out the cause and eliminate it.
2. For ultrasonic braiding, put the material in the middle in manual mode before starting the machine. Before starting, check whether the braiding controller is in automatic mode before starting the work.
3. When turning on the machine, slowly increase the speed and look at the upper and lower knives. The gap should not be too large. If it is too large, there will be burrs. If it is too small, it will damage the blade.
4. When calibrating the knife, when the upper knife is lowered and is 2~3mm away from the lower knife, the upper knife holder should be locked, align it with the middle of the lower knife edge groove, and then lower the upper knife holder to prevent the upper knife edge from touching the lower knife. When calibrating the knife, be sure to lock the upper knife rest to prevent the upper knife rest from loosening, causing the knife to jump during slitting.
5. Note: The machine should be grounded before use to prevent electric shock.

