How to correctly install the slitting machine
Jun 16, 2025
Leave a message
The following are the steps and key points for correctly installing the slitting machine:
1. Installation Preparation
Site selection: Select a spacious, bright and flat factory area to ensure that there is enough space for equipment installation, operation and subsequent maintenance. At the same time, consider ventilation and drainage conditions to avoid humid environment affecting equipment performance.
Tool preparation: Prepare the tools required for installation, such as wrenches, screwdrivers, levels, cranes, etc., and ensure that the tools are in good condition and the accuracy meets the requirements.
Equipment inspection: Before installation, carefully check whether all parts of the slitting machine are complete, whether there is any damage or deformation, and whether the accompanying technical documents, certificates, etc. are complete.
2. Foundation construction
Foundation design: Design a suitable concrete foundation according to the weight, size and stress of the slitting machine during operation. The foundation should have sufficient strength and stability to withstand the vibration and impact of the equipment during operation.
Foundation construction: Carry out foundation construction according to design requirements. When pouring concrete, pay attention to reserving anchor bolt holes and cable trenches, etc. The foundation surface needs to be flat, and the levelness error should be controlled within the specified range.
3. Equipment Installation
Component placement: Use a crane to hoist the various components of the slitting machine onto the foundation in the order of installation, and make preliminary adjustments to make them roughly meet the installation requirements. For heavier components, such as the main machine, unwinder, winder, etc., ensure that they are placed stably to avoid tilting or shaking.
Installation of anchor bolts: Place the anchor bolts into the reserved holes, adjust the position and verticality of the bolts, and then pour concrete to fix them. During the solidification of the concrete, check the position of the anchor bolts regularly and adjust them in time if there is any deviation.

Equipment connection: Connect various components according to the equipment installation instructions, such as installing transmission belts, chains, pipes, etc., and ensure that the connection is firm and reliable. At the same time, connect the electrical lines, pay attention to the correctness and safety of the wiring, and the grounding system should be well connected to ensure the safe operation of the equipment.
4. Accuracy adjustment
Horizontal adjustment: Use a spirit level to adjust the horizontality of the main machine, unwinder, rewinder and other components of the slitting machine, and adjust the height of the anchor bolts to make the equipment reach the specified horizontality requirement.
Tool installation and adjustment: When installing the tool, ensure the installation accuracy of the tool and adjust the tool gap and verticality to meet the shearing process requirements.
5. Test run
No-load test run: After the installation is completed, carry out no-load test run. Check the operation of each component of the equipment, such as whether the motor, reducer, transmission device, etc. are running smoothly, and whether there is abnormal noise and vibration. At the same time, check whether the control system is working normally, and whether each operating button and switch is sensitive and reliable.
Load test run: After the no-load test run is normal, carry out the load test run. Gradually increase the thickness and width of the sheared material, observe the operation of the equipment under different load conditions, and check whether the shearing accuracy, winding quality, etc. meet the requirements. If any problems are found, stop the machine in time for inspection and adjustment until the equipment runs normally.
If you want to know more about slitting machines, please contact Jinye Complete Equipment . Our technical team will tailor the most suitable product solution for you.

