Reasons why the slitting line blade becomes bent
Oct 09, 2023
Leave a message
As we all know, the slitting line is to cut metal coils into strips of the required width, and then collect the strips into small rolls for use in the next process. It is an equipment for shearing metal strips in the transformer, motor industry and other metal strips. Sometimes the slitting line blade may become bent. So what is the reason?
When the slitting line is processing metal sheets, if the speed of the correction device is too fast or too slow, the sickle will bend.
First, the defects of the metal plate should be checked, then the accuracy of the metal slitting line should be adjusted, and then the winding and tension of the metal plate should be controlled. Of course, specific issues need to be analyzed in detail.
The metal plate itself is not smooth. When winding the coil, the internal stress is not completely eliminated. When the coil is sheared, internal stresses will act on the sickle, causing it to bend.
If there is an external force on both sides of the board that bends outward, the lath will bend.
The burrs on the metal sheet of the slitting line bent the sickle. When the slitting machine cuts the metal plate, the gap adjustment of the blade is unreasonable, resulting in burrs. The larger the gap, the larger the burr. When the metal sheet is rolled up, the edges will bend because of the burrs.
The gap between the upper and lower blades is asymmetrical, causing the sickle to bend. Since the gap between the left and right sides of the feed chute is relatively large, the indentation will be relatively large, so the coil will stretch relatively large, and a sickle bend will naturally occur.
When the sickle bends due to uneven tension, the tension on the baffle will increase during winding, so that the unilateral tension will cause the sickle to bend.
The bending of the slitting line blade mainly includes the above reasons. In the above introduction, we can easily see the importance of the bending of the slitting line blade. Pay attention when installing the blade.

