What are the solutions after the slitting line fails?
Oct 10, 2023
Leave a message
Slitting lines are widely used in the mechanical processing industry. Although the quality of the slitting line is good, failures will inevitably occur during use. Check whether the hole cover of the slitting line is too thin. After the bolts are tightened, the contact gap is prone to deformation and oil leakage. The tank filter device is the medium through which hydraulic oil enters the tank from the outside of each hydraulic tank. Before the hydraulic oil enters the slitting line oil tank, it needs to pass through a filter device. The filter device is one of the important factors that determine the stability of the slitting line. Pay attention to the gasket effect. The gasket between the automatic and static parts of the slitting line acts as a leak-proof seal.
1. When rolling narrow cylinder, it should be placed in the middle position of rolling.
2. After the workpiece enters the slitting line roller, avoid getting your hands and clothes involved in the roller.
3. The workpiece needs to be placed stably and can only be started after it is in place. The signal must be clear and one person must be designated to take command.
4. Do not put your hands on the rolled steel plate. It is strictly prohibited to use the template for inspection after the machine has stopped. Use the template to check roundness.
5. When the pressure of the rolled workpiece is insufficient, please leave a margin when rolling to the end of the steel plate to prevent the workpiece from falling and injuring people.
6. When working, it is prohibited to stand on the workpiece or look for roundness on the rolled cylinder.
7. When rolling large-diameter cylinders or high-intensity workpieces, it is necessary to add some moving rollers and repeat the forming. Don't worry when the slitting line doesn't turn during use. First stop the operation of the slitting line, check where there are problems, and then take appropriate measures to solve the problems.
Generally, the slitting line runs during most of the working time. During breaks, it is necessary to interrupt the oil temperature reduction of the slitting line and the cooling effect of each component. In response to the above problems, we need to analyze product quality. Installation with unqualified specifications will not easily result in seal leakage protection, and may even lead to accidents. Valve oil leakage is usually caused by clogged or damaged valves, and the response is to replace the valves. Check the installation of the cylinder and oil port as soon as possible to ensure that there are no gaps in the sealed slitting line. If found, it needs to be replaced immediately. Remove the failed oil seal as soon as possible. Many moving parts on the slitting line are not installed correctly. The center position of the shaft and the oil seal cutting edge is inconsistent, and other reasons may cause the oil to be thrown away. Some oil seals will lose their elasticity due to rubber aging if used for too long, preventing the one-way valve and exhaust valve from clogging. Therefore, when the temperature in the oil tank of the slitting line increases, the oil and gas cannot be discharged to the entire space, the pressure in the oil tank increases, the lubricating oil consumption increases, and the cycle shortens. During the maintenance period of the slitting line, oil leakage may occur due to the dirt on the contact surface not being cleaned, improper selection of sealant, reversal of sealing direction, and failure to replace seals as soon as possible. Due to the interference of the air pressure difference inside and outside the casing, soft seal oil leakage often occurs. Therefore, it is necessary to check, dredge and clean the hydraulic press regularly.

