Do You Know The Safe Operation Steps Of The Slitting Machine?
Oct 18, 2023
Leave a message
1. Send electricity. Close the air switch in the control cabinet and the power indicator light of the slitting machine will light up. Be careful not to touch the wiring terminals with your fingers. Be careful of electric shock and endanger safety.
2. Top the curtain roll. Open the guide safety chuck, hang up the curtain roll, close the safety chuck, separate the curtain fabric and tape, and wind the curtain fabric onto the winding cloth barrel.
3. Manually spread the tape. The guide is opened manually, forward and inched, and the tape is manually dragged through the correction roller, tension roller, brake roller, and driving roller.
4. Pull out the thread. Use scissors to cut the rubber strip according to the size of the rubber strip to be produced, then draw out the thread and fix it on the thread drawing roller.
5. Upper curling roller. Remove the square shaft at the end of the coiling shaft, install 30 nylon reels, then install the upper shaft, open the coiling safety chuck, and install the coiling shaft. The operations of coiling 1 and coiling 2 are the same.
6. Put on the tape head. Stretch the strip to the appropriate position and wrap the strip onto the reel. Pay attention to keeping the length of the strip consistent to keep the strip tension consistent.
7. Adjust the tension. Adjust the winding tension to between 6.5-10, and adjust the unwinding tension to between 10-15. Note that as the winding diameter increases, the curling tension increases appropriately to ensure consistent strip tension.
8. Adjust the coiling speed. Adjust the winding speed within the required range. Note that the winding speed cannot be too high when starting to avoid correction and tracking errors. It can be adjusted to 20 and then increase the speed after starting.
9. Start the machine. After the above operation is completed, press the start button, rotate it for one or two turns, and observe whether the rubber strip of the reel is deflected out of alignment. If so, stop winding, correct the position, and then continue to rotate. At the same time, pay attention to the position of the thread end to adjust the start and stop of the thread withdrawal to prevent the thread end from being pulled or pinched.
10. Adjust the tightness of the take-up rubber strip. If the tape is loose, it is usually due to the thickness of the tape, which causes the winding diameter to become smaller. Plastic pads can be added to increase the diameter to increase the diameter to ensure that the tension is consistent with other tapes.
11. Stop the machine after coiling is completed. When the crimp diameter reaches 160 mm, stop the machine.
12. Unload the product. Cut off the rubber strip, loosen the safety chuck, lift up the winding shaft, remove the lower shaft, and remove the product. Be careful to separate the products in time and do not overlap them to prevent them from sticking together.
13. Prepare for the next coiling.
14. If the machine is not used for a long time, please turn off the main power supply of the machine.

